Rip cut the starter strip or starter pieces so that they butt up against the second course of existing shingles and are even with the front edge of the existing roofing.
New roof shngle seem easy to pull up.
Multilayer roofs it is always better to tear off your old roof and install a new one.
Morning all i m currently looking at a roof replacement hail claim and am looking for opinions.
Start at the end and move in and down.
While it is wise to have your roof completely removed and replaced it is possible to replace the top layer of shingles alone.
In most cases you can remove nails under the shingles on both sides of the vent to pull it free.
Do this by sliding hard under the layers of shingle and paper then pry upward.
Starting at the ridge use your shovel to pry off old shingles.
There will be nails across the top of the vent too.
Press the piece of felt paper into the fresh cement making sure the crease in the paper faces up towards the roof.
If more than about 35 of your roof is going to need repair due to wind or hail especially if it s already 12 years old the cost effective decision might be to replace it all.
Warped shingles might seal down eventually but they re more difficult to install and the gaps that result are more likely to catch the wind and cause the edge of the shingle pull away from the.
So if the old roof had a bumpy or lumpy appearance the new layer will as.
Repeat this basic pattern alternating shingles across the roof working toward the right side using the chalk line to keep the shingles straight horizontally.
However the new shingles will keep to the form of the old layer.
If it is not flat apply additional asphalt cement under the lower edge of the shingle and press down until the shingle behaves and lays flat.
There will be nails across the top of the vent too.
The shingle can now be laid back flat on the roof.
Attach with nails along the top edge of the strip.
If you have a tight budget and the asphalt roofing shingles are not in extremely poor condition then this may be your best option for a new roofing.
Use a starter strip or cut pieces for a starter course.
Repair is costlier on a per square foot basis because it is more time consuming to integrate new shingles into a roof here and there than to install them over the entire roof.
Use 4 nails per shingle and 6 nails on the prevailing windward sides of the roof as wind resistance nailing.
This can reduce costs by at least 1 000.
If no ridge vent is present use your shovel to remove the shingle cap on the ridge.